Multi-Function Magazine Buffer
Standard features
- 5 operation modes available: Buffer mode (LIFO), Unload mode, Load mode, Reject mode, By-pass mode
- Panasonic PLC Program control
- Selectable pitch settings
- Dual function pusher conveyor
- Towerlight display for machine status
- Additional magazines buffing capacity available upon request
- Exchange magazine from the rear of the machine
- Automatic magazine alignment by upper- and lower pneumatic clamping
- Regulated pressure on attached pneumatic pusher
- Pusher position adjustable to centre of the magazine
- SMEMA compatible
LIFO Vertical Buffer
Standard features
- Panasonic PLC Program control
- Buffer in LIFO and by-pass mode
- Selectable pitch settings
- Enclosed construction improve level of safety
- The status of each slot can be changed independently
- Conveyor width adjustment using hand wheel
- Threshold signal to protect PCB’s in upstream oven
- User friendly touchscreen control panel
- Towerlight display for machine status
- SMEMA compatible
Options
- Automatic width adjustment (set in touchscreen)
- Additional PCB boards capacity
- Cantilevered input- or output conveyor (length 500 mm)
- Other options available on request
Multi-Function Buffer (FIFO)
Standard features
- Panasonic PLC Program control
- Selectable FIFO, LIFO and by-pass mode
- Selectable pitch settings
- Enclosed construction improve level of safety
- The status of each slot can be changed independently
- Conveyor width adjustment using hand wheel
- Threshold signal to protect PCBs in upstream oven
- User friendly touchscreen control panel
- Towerlight display for machine status
- SMEMA compatible
Options
- Reject mode for buffering bad board
- Additional PCB boards capacity
- Automatic conveyor width adjustment
- Cantilevered input- or output conveyor (length 500 mm)
- Other options available on request
NG/OK Vertical Buffer
Standard features
- Panasonic PLC Program control
- Selectable FIFO, LIFO and by-pass mode
- Selectable pitch settings
- Input conveyor is standard included
- Conveyor width adjustment using hand wheel
- Threshold signal to protect PCB’s in upstream oven
- NG/OK table provides easy access to the NG PCBs
- Towerlight display for machine status
- Good or bad board separation
- SMEMA compatible
Inverter/Flip Conveyor
Standard features
- Pannasonic PLC Program control
- By-pass mode selectable
- Pneumatic stopper to keep PCB in position during inverting
- Smooth and parallel width adjustment (lead screw)
- SMEMA compatible
Options
- Automatic width adjustment (set in touchscreen)
- Cantilevered input- or output conveyor (length 500 mm)
- Touchscreen instead of button panel
- Other options available on request